Sony VGF-CP1U - Manual (Page 54)


VGF-CP1 Series 3-300-630-31(1)
11
If the connection name is unnecessary to change, press  on the remote
control to proceed to the next step.
The confirmation screen for settings appears.

Hint
Normally it is unnecessary to change the connection name.
12
Confirm the setting, and press  on the remote control to proceed to the next
step.
13
Select [Yes] by pressing   on the remote control, and press (ENTER).
Connection to the access point is confirmed. When connected properly, “Network connection
completed” is displayed.
Setting Manually
If the access point device does not support AOSS, or AOSS does not work properly, set manually by the
following steps.
1
Confirm the access point information.
Confirm the following information. For details on the access point device (wireless LAN router), see the
operating instructions supplied with the access point device, or consult the access point provider.
 SSID
Identification for the access point.
 Security type
Security type depends on the access point. With this unit, [None], [WEP], [WPA-PSK (TKIP)], [WPA-
PSK (AES)] can be selected.
 Encryption key
WEP key or WPA key is required depending on the selected security type.
2
Display the screen below by following steps 1 to  in “Setting with AOSS” (page
1).