Sony DCR-PC100 - Manual (Page 120)

120
Symptom Cause and/or Corrective Actions
• The write-protect tab on the “Memory Stick” is set to
LOCK.
c Set the tab to write. (p. 84)
• The battery pack is dead.
c Install a charged battery pack or use the AC power
adaptor instead of the battery pack. (p. 10, 13)
Others
Symptom Cause and/or Corrective Actions
• The tape has no cassette memory.
c Use a tape with cassette memory. (p. 68, 114)
• The cassette memory is full.
c Erase another title. (p. 71)
• The tape is set to prevent accidental erasure.
c Slide the write-protect tab so that red portion is not
visible. (p. 14)
• Nothing is recorded in that position on the tape.
c Superimpose the title to the recorded position. (p. 68)
• The tape has no cassette memory.
c Use a tape with cassette memory. (p. 74, 114)
• The cassette memory is full.
c Erase some titles. (p. 71)
• The tape is set to prevent accidental erasure.
c Slide the write-protect tab so that red portion is not
visible. (p. 14)
• Disconnect the i.LINK cable (DV connecting cable), and
connect it again.
• The input selector on the VCR is not set correctly.
c Set the selector to DV input position. If you use another
DV camcorder, set the power switch to VTR.
• The camcorder is connected to DV equipment of other
than Sony.
c Operate normal editing.
• Setting program on a blank portion of the tape is
attempted.
c Set the program again on a recorded portion.
Troubleshooting
The cassette label is not recorded.
While editing using the i.LINK cable
(DV connecting cable), recording
picture cannot be monitored.
DV synchro-editing does not
function.
The photo save function does not
work.
The title is not recorded.