Sony DCR-PC100 - Manual (Page 63)

63
Editing
To change the insert end point
Press ZERO SET MEMORY on the Remote Commander again after step 5 to erase the
ZERO SET MEMORY indicator and begin from step 3.
Using the Remote Commander
In step 5, press zREC and MARK simultaneously, then immediately press X. And in
step 6, press X at the scene where you want to start recording from.
Note
The picture and sound recorded on the portion between the insert start and end points
will be erased when you insert the new scene.
If you insert scenes on the tape recorded with other camcorder (including other
DCR-PC100)
The picture and sound may be distorted. We recommend that you insert scenes on a
tape recorded with your camcorder.
When the inserted picture is played back
The picture and sound may be distorted at the end of the inserted portion. This is not a
malfunction.
The picture and sound at the start point and the end point may be distorted in the LP
mode.
To insert a scene without setting the insert end point
Skip steps 3 and 4. Press x when you want to stop inserting.
Inserting a scene from a VCR – Insert editing