Sony DCR-PC100 User Manual
Page 92
92
Recording still images on “Memory Stick”s – Memory photo
recording
While you are recording a still image
You can neither turn off the power nor press PHOTO.
When you press PHOTO on the Remote Commander
Your camcorder immediately records the image that is on the screen when you press
the button.
Notes
•When recording still images at step 2 with the PHOTO button pressed lightly, the
image momentarily flickers. This is not a malfunction.
•Before you shoot in autofocus mode, check that the subject is in sharp focus.
•The brightness of the picture and focus are adjusted on the center portion of the image.
When recording in MEMORY mode
The angle of view is a little increased than one in CAMERA mode.
Recording images continuously
You can record still pictures continuously. Select one of the two modes described below
before recording.
Continuous mode [a]
When the image size is set to 1152
×
864, you can record up to four pictures
continuously.
When the image size is set to 640
×
480, you can record up to 16 pictures continuously.
The number of recorded photos in continuous mode depends on the capacity of the
“Memory Stick.”
Multi screen mode (Image size is automatically set to 640
×
480) [b]
You can record nine still pictures continuously on a single page.
While pressing down PHOTO, the camcorder shoots still pictures continuously. The
maximum recordable number of still pictures (1152
×
864: up to four pictures, 640
×
480:
up to 16 pictures) is in accordance with the image size setting.
If you release the button during shooting, the recording stops even in progress.
When shooting with the self-timer function or the Remote Commander, the camcorder
automatically records up to the maximum recordable number of still pictures.
(1) Set the POWER switch to MEMORY. Make sure that the LOCK switch is set to
the right (unlock) position.
(2) Press MENU to display the menu.
(3) Turn the SEL/PUSH EXEC dial to select
, then press the dial.
(4) Turn the SEL/PUSH EXEC dial to select CONTINUOUS, then press the dial.
(5) Turn the SEL/PUSH EXEC dial to select the desired setting, then press the dial.
[a]
[b]