Sony DCR-PC100 - Manual (Page 122)

122
C:21:00
Self-diagnosis display
Five-digit display Cause and/or Corrective Actions
• You are using a battery pack that is not an
“InfoLITHIUM” battery pack.
c Use an “InfoLITHIUM” battery pack. (p. 11)
• Moisture condensation has occurred.
c Remove the cassette and leave your camcorder for at
least one hour to acclimatize. (p. 126)
• The video heads are dirty.
c Clean the heads using the Sony DVM12CL cleaning
cassette (not supplied). (p. 127)
• A malfunction other than the above that you can service
has occurred.
c Remove the cassette and insert it again, then operate
your camcorder.
c Disconnect the power cord of the AC power adaptor or
remove the battery pack. After reconnecting the power
source, operate your camcorder.
• A malfunction that you cannot service has occurred.
c Contact your Sony dealer and inform them of the 5-digit
code. (example: E:61:10)
If you are unable to rectify the problem even if you try corrective actions a few times,
contact your Sony dealer.
Your camcorder has a self-diagnosis display
function.
This function displays the current condition of
your camcorder as a 5-digit code (a combination of
a letter and figures) on the LCD screen or in the
viewfinder. If a 5-digit code is displayed, check the
following code chart. The last two digits (indicated
by ss) will differ depending on the state of your
camcorder.
C:21:ss
Viewfinder (or LCD screen)
Self-diagnosis display
•C:ss:ss
You can service your camcorder
yourself.
•E:ss:ss
Contact your Sony dealer.
E:61:ss
E:62:ss
C:31:ss
C:32:ss
C:04:ss
C:22:ss