When the remote control is missing, Sequential display mode, 14 when the remote control is missing – Panasonic BL-MS103A User Manual
Page 139: 1 sequential display mode
14
When the Remote Control is Missing
[For assistance, please call: 1-800-272-7033]
139
14 When the Remote Control is Missing
14.1 Sequential Display Mode
The BL-WV10A requires the remote control to operate. If you lose your remote
control, contact your dealer to purchase a new one (part number PSWEWV10A).
Even without a remote control, however, setting the mode switch to [SEQ. DISP.]
will allow you to view sequentially the screens from registered cameras.
1.
Set the BL-WV10A's mode switch to [SEQ. DISP.] and turn it on again.
•
After the launch screen, the Camera Monitoring Screen will appear.
•
At a fixed interval, the display will run through each of the registered
camera screens.
Note
•
Use of the remote control during Automatic Display mode will display the
following and fail to work.
m
•
Automatic Display mode is for display only; you will be unable to record.
•
All registered cameras, local and remote, will be displayed sequentially. If,
however, a remote camera has been set to not save its password, its
screen will be skipped and the next screen displayed.
•
If there is no connection with a camera, because it is turned off, etc., a
message indicating that the camera could not be accessed with appear for
between 5 and 10 seconds, after which the next camera's image will
appear.