Panasonic BL-MS103A - Manual (Page 99)

6 Setup Menu
[For assistance, please call: 1-800-272-7033] 99
Note
• If you forget the security code, you will be unable to enter the Setup
screen, and you will need to reset the BL-WV10A. Doing so, however, will
reset all of your settings to their defaults, and sever the connections to
the cameras. If necessary, write down the security code and store it in a
secure place.
• The security code must be 4 digits in length.
• If you forget the security code, push the FACTORY DEFAULT RESET button to
restore the BL-WV10A's default settings (see page 131). You will need to re-
perform Quick Setup to register the cameras and set desired settings again.
• Setting the volume to off will turn off both the buzzer and any operational
sounds.
• To turn off the volume for the buzzer in Sensor Alert mode only, press [ALERT].
Network Settings
Change the settings for the BL-WV10A's network information.
Note
• If the BL-WV10A will not be connected to a network (the BL-WV10A will only
be connected to cameras), these settings can be ignored.
Setting Description
IP Address/
Subnet Mask Set the IP address and subnet mask for the BL-WV10A.
Gateway Set the gateway address
DNS1/DNS2 Set the IP address for the DNS server.
Up to 2 DNS server addresses can be set.
Proxy Server/
Proxy Port If you will use a proxy server to view camera images, enter its
name and port number here.