Panasonic BL-MS103A - Manual (Page 72)

4 Recording Images
72
• See page 84 for more information on recording frame rates for sensor
recording.
*When recording in LOW or LONG mode, a smaller image is recorded and the
image appears smaller during playback.
• We recommend using a recording mode of either HIGH or LOW for sensor
recording.
4.1 SD Memory Cards
We recommend using Panasonic SD memory cards with the BL-WV10A.
(We cannot guarantee the performance of SD memory cards made by other
manufacturers.) Cards with capacities of up to 1 GB can be used.
CAUTION
When the timer/access indicator is flashing amber, data is either being read from
or written to the card. When the indicator is flashing amber, do not do any of the
following:
• Remove the SD memory card.
• Turn off the BL-WV10A.
• Press the FACTORY DEFAULT RESET button.
Doing so can result in corrupted data on the SD memory card. If this occurs, the
card cannot be used and you will need to reformat the card with the BL-WV10A.
All data on the card will be erased.
Note
• Do not use the SD memory card used for the BL-WV10A in other devices
(digital cameras, video cameras, etc.). Only image data (movies and
pictures) that were recorded with the BL-WV10A can be viewed with the
Record Mode Resolution Image Refresh Interval
HIGH 640 x 480 1 sec.
LOW 320 x 240* 1 sec.
LONG 320 x 240* 5 sec.
Push the SD memory card
slightly, then remove it
Ejecting an SD memory card
Timer/Access
indicator
Inserting an SD memory card
Insert label
side up,
with notch
on right side