Park/pick up key, Park/pick up key -234, The section – Aastra Telecom 9480i Series User Manual
Page 532: Draft 1
Operational Features
5-234
41-001160-03, Rev 00, Releaes 2.4
IP Phone Administrator Guide
Park/Pick Up Key
The IP phones (including the 6757i CT and 9480i CT handsets) have a park and
pickup call feature that allows you to park a call and pickup a call when required.
There are two ways a user or administrator can configure this feature:
•
Using a static configuration (globally configures park and pickup)
•
Using a programmable configuration (using a key)
The IP phones support the Park/Pickup feature on the Asterisk, BroadWorks,
Sylantro, and ININ PBX servers.
The following paragraph describes the configuration of a park and pickup key on
the IP phone. For information about configuring the park and pickup static
configuration method see
“Park Calls/Pick Up Parked Calls”
.
Park/Pickup Programmable Configuration (using a key)
The programmable method of configuration creates park and pickup keys
(softkeys, programmable keys, expansion module keys) that you can configure on
the IP phones.
For the 9480i, 9480i CT, 6755i, 6757i, and 6757i CT you can set a key as "Park"
or "Pickup" and then:
•
specify a customized label to display on the Phone UI
•
specify a value
•
specify which line to use
•
specify the state of the park and/or pickup keys
For the 9143i and 6753i, you can set a programmable key as "Park" or "Pickup"
and then:
•
specify a value
•
specify a line to use
Note:
The IP phones accept both methods of configuration. However, to
avoid redundancy, Aastra Telecom recommends you configure either a
static configuration or a programmable configuration.
Draft 1