Vaddio BRC-H900 Operating - Manual (Page 56)

In
s
ta
llat
ion
a
nd
Conne
c
tio
ns
Installation
GB 56
Installing the Camera
To install the camera on a desk
Place the camera on a flat surface.
If you have to place the camera on an inclined surface,
make sure that the inclination is less than ±15 degrees,
so that the pan/tilt performance is guaranteed, then
ensure the camera does not fall.
Notes
• You should take an appropriate countermeasure to
prevent the camera from falling.
• Do not grasp the camera head when carrying the
camera.
• Do not turn the camera head by hand. Doing so may
result in the camera malfunctioning.
To attach the camera to a tripod
Attach a tripod to the tripod screw hole on the bottom of
the camera.
The tripod must be set up on a flat surface and tightened
firmly by hand.
Use a tripod with screws of the following specifications.
Installing the Camera in a High
Position
Using the supplied ceiling brackets, wire rope and
screws, and attachment materials (not supplied), you can
attach the camera to a ceiling or on a shelf, etc., in a high
position.
When you install the camera, always install it on a level
surface. If you have to install it on an incline, make sure
that the inclination is within ± 15 degrees, so that the
pan/tilt performance is guaranteed.
Installation of the camera using the tripod screws and
screw holes should not be done for installation on a
ceiling or a shelf, etc., in a high position.
• When you attach the camera to a ceiling or shelf,
etc., in a high position, entrust the installation to an
experienced contractor or installer.
• Attach the camera to the ceiling or shelf, etc., firmly,
after making sure the surface and the attachment
materials (not including the supplied accessories)
are strong enough to bear a weight of 60 kg (132 lb
4 oz). If the ceiling or shelf, etc., is not strong
enough, the camera may fall and cause serious
injury.
• Be sure to attach the supplied wire rope to prevent
the camera from falling.
• Check periodically, at least once a year, to ensure
that the connection has not loosened. If conditions
warrant, make this periodic check more frequently.
1 / 4 -20UNC
= 4.5 – 7 mm
= 0.18 – 0.27 inches
Caution
Caution