Goulds Pumps NM 3196 i-FRAME - IOM - Manual (Page 28)

2. Install the lower part of the stilt assembly:
a) Screw the lower jam nut and adjusting nut onto the stilt.
b) Set the lower adjusting nut to the correct height.
The correct height depends on the required distance between the foundation/floor and the
baseplate.
c) Put a washer onto the lower adjusting- nut.
3. Install the stilt assembly on the baseplate:
a) Insert the stilt assembly into the baseplate's anchorage hole from below.
b) Put a washer onto the stilt.
c) Fasten the stilt assembly with the upper adjusting nut by hand.
4. Screw the upper jam nut onto the stilt by hand.
5. Repeat steps 2 through 4 for all the stilt assemblies.
6. Lower the baseplate so that the stilts fit into the foundation cups.
7. Level the baseplate and make the final height adjustments:
a) Loosen the upper jam nuts and adjusting nuts.
b) Adjust the height and level the baseplate by moving the lower adjusting nuts.
c) When the baseplate is level, tighten the top adjusting nuts.
8. Fasten the lower and upper jam nuts on each stilt.
1
2
3
4
5
6
7
8
1. Mounting plate
2. Mounting nut
3. Stilt bolt
4. Foundation cups
5. Washer
6. Upper adjustment nut
7. Mounting washer
8. Mounting bolt
Figure 10: Example of an installed stilt assembly
Installation
26 Model NM 3196 i-FRAME Installation, Operation, and Maintenance Manual