Assemble the inpro labyrinth oil seal, Assemble the c-face adapter – Goulds Pumps NM 3196 i-FRAME - IOM User Manual
Page 93
NOTICE: The INPRO VBX is a one-piece design. Do not attempt to separate the rotor from the stator
before or during installation. Doing so may result in equipment damage.
A
B
C
A
"VBX" O-ring action
B
Static
C
Dynamic
1
Rotor
2
Stator
3
"VBX" ring
4
Rotor drive ring
5
Stator gasket
6
Expulsion port
7
D groove
8
Lube return
9
Location shoulder
Assemble the INPRO labyrinth oil seal
1. Wrap electrical tape around the coupling end of the shaft to cover the keyway.
NOTICE: The edges of the keyway can be sharp. Make sure to cover the keyway with tape. Failure to
do so may result in cutting the O-ring and damaging the seal.
2. Lightly lube the shaft and the drive ring (4) with lubricant.
Lubricant helps in the installation process. Be sure that the lubricant is compatible with the O-ring
material and the pump-system standards.
3. Use an arbor press to install the outboard INPRO VBXX-D into the bearing cover with the expulsion
port (6) at the 6 o'clock position.
Press the outboard INPRO VBXX-D down to where the stator location ramp (9) starts to avoid
angular misalignment. There is a nominal 0.002 in. (0.051 mm) interference fit.
4. Discard any residual material from the stator gasket (5).
5. Complete the applicable step in this table depending on the model of your pump.
Pump model
Action
STi
Press the inboard seal along the shaft into the bearing frame.
All other models After you install the frame adapter on the bearing frame, press the inboard seal over
the shaft and into the adapter.
Assemble the C-face adapter
1. Mount the pump and the motor-coupling hubs if they are not already mounted.
Maintenance
Model NM 3196 i-FRAME Installation, Operation, and Maintenance Manual
91