Safety, Warning, Caution – Comfort-Aire HTS Series Split System,Two Stage, 2-5 Tons User Manual

Page 4

Advertising
background image

Safety

4

Installation, Operation & Maintenance

HTS SERIES SPLIT SYSTEM

Heat Controller, LLC

WARNING!

Verify refrigerant type before proceeding.

Units are shipped with R-410A refrigerants. The unit label
will indicate which refrigerant is provided. The EarthPure®
Application and Service Manual should be read and
understood before attempting to service refrigerant circuits
with R-410A

Safety

Warnings, cautions and notices appear throughout this
manual. Read these items carefully before attempting any
installation, service or troubleshooting of the equipment.

DANGER: Indicates an immediate hazardous situation,
which if not avoided will result in death or serious injury.
DANGER labels on unit access panels must be observed.

WARNING: Indicates a potentially hazardous situation,
which if not avoided could result in death or serious injury.

CAUTION: Indicates a potentially hazardous situation or an
unsafe practice, which if not avoided could result in minor or
moderate injury or product or property damage.

NOTICE: Notifi cation of installation, operation or
maintenance information, which is important, but which is
not hazard-related.

WARNING!

WARNING!

WARNING!

WARNING!

To avoid the release of refrigerant into the

atmosphere, the refrigerant circuit of this unit must be
serviced only by technicians who meet local, state, and
federal profi ciency requirements.

CAUTION!

WARNING!

All refrigerant discharged from this unit must

be recovered WITHOUT EXCEPTION. Technicians must
follow industry accepted guidelines and all local, state,
and federal statutes for the recovery and disposal of
refrigerants. If a compressor is removed from this unit,
refrigerant circuit oil will remain in the compressor. To
avoid leakage of compressor oil, refrigerant lines of the
compressor must be sealed after it is removed.

CAUTION!

To avoid equipment damage, DO NOT use

these units as a source of heating or cooling during the
construction process. The mechanical components and
fi lters will quickly become clogged with construction dirt
and debris, which may cause system damage.

Advertising