Festo Контроллер крайних положений SPC11 - Manual (Page 29)

2. Parameters of the SPC11 for DNCM-..-POT
2-3
Festo P.BE-SPC11-DNCM-EN en 0204NH
2.1 Parameters of the SPC11
Warning
Incorrectly set parameters can damage the fixed stops and
the drive.
Be very careful when setting the parameters.
The SPC11 must be familiar with certain conditions of use.
These conditions of use are described by the three following
parameters:
Parameters Manual
Amplification stage
(amplification stage) Influences the acceleration behaviour of the
drive
Cushioning stage
(cushioning stage) Influences the retracting behaviour when
moving to the end positions and inter-
mediate positions.
System parameters
(system parameters) Characteristic value for the structure of the
drive
Valid parameters for operating the SPC11 with drive type
DNCM-...-POT can be found in section 2.3. These parameters
are matched exactly to the specified combinations of drives,
valves and mass loads for horizontal operation.