Festo Контроллер крайних положений SPC11 - Manual (Page 15)

1. Summary of components
1-3 Festo P.BE-SPC11-DGP-EN en 0012NH
1.1 General instructions
Warning
Faults in the system structure as well as incorrectly set
parameters can cause the slide to move uncushioned into
one of the end positions. This may cause damage to the
fixed stop or to the drive. Please observe the following
instructions in order to prevent such collisions.
S Set up the system with the greatest care. Observe at all
times the safety instructions and information in this
manual as well as in the System manual type P.BE-
SPC11-SYS... .
S Use only the matching components from Festo for setting
up and wiring the system. Only then can the correct func-
tioning of the system be guaranteed.
Please note
For operating the DGPI(L)- ... you will require the SPC11
type SPC11-MTS-AIF. For operating the DGP(L)-... with the
MLO-POT-...-TLF measuring system you will require the
SPC11 type SPC11-POT-TLF.