Designated use – Festo Электрический терминал СРХ User Manual
Page 7
Contents and general instructions
V
Festo P.BE−CPX−CEC−E N en 1004a
Designated use
The type CPX−CEC/CPX−CEC−...
CoDeSys controller
documĆ
ented in this manual is intended exclusively for use in Festo
CPX terminals for installation in a machine or an automation
control system.
In combination with a CPX terminal, the CPX−CEC/CPX−CEC−...
is used for
ć
controlling pneumatic and electric actuators (valves, outĆ
put modules and motor controllers via CANopen)
ć
interrogating electric sensor signals through the input
modules
ć
communication via Ethernet.
The CPX terminal with the CPX−CEC/CPX−CEC−... may only be
used as follows:
ć
as designated in industrial applications
ć
without any modifications by the user. Only the converĆ
sions or modifications described in the documentation
supplied with the product are permitted
ć
in faultless technical condition
ć
only in combination with approved components
(e. g.Ăvalves, drive/displacement encoder combinations).
The limit values specified for pressures, temperatures, electriĆ
cal data, torques etc. should be observed.
Please comply with the regulations of the workers’ comĆ
pensation insurance association, the German Technical ConĆ
trol Board (TÜV) and the electrical requirements of the VDE or
the corresponding national and local safety regulations.