Festo Электрический терминал СРХ - Manual (Page 61)

3. Commissioning
3−9
Festo P.BE−CPX−CEC−E N en 1004a
3.5 Parameterisation of the CPX terminal
The CPX terminal is supplied from the factory with preset
parameters. If required, you can set the reaction of the CPX
terminal as well as the reaction of individual modules and
channels by parameterising.
A distinction is made between the following parameterisaĆ
tions:
ć system parameters, e.g.: switching off fault messages,
setting reaction times, etc.
ć module parameters (module and channel−specific), e.g.:
monitoring, settings in the event of faults, settings for
forcing
ć diagnostic memory parameters.
Detailed specifications on the parameters and data as well as
basic information on parameterisation of the CPX terminal
can be found in the CPX system manual type P.BE−CPX−SYS−....
Detailed information on the module parameters can be found
in the user documentation of the respective modules.
The following parameterisation options are available:
Parameterisation via ... Description Properties
Control configuration in
CoDeSys: logout Access to all parameters of
the CPX terminal Ĉ Convenient parameterisation via a PC
Ĉ Parameterisation is stored in the
project, i.e. the parameters remain
after Power OFF/ON
Handheld type CPX−MMI Parameterisation is carried
out via menu−listed entries
with the handheld Ĉ Parameterisation is saved only locally
in the CPX terminal and is lost with
Power OFF/ON
Tab. 3/1: Parameterisation options