Kramer Electronics VP-8x4 - Manual (Page 8)

Your VP-8x4 8x4 VGA / UXGA Matrix Switcher
5
Table 1: Front Panel VP-8x4 8x4 VGA / UXGA Matrix Switcher Features
# Feature Function
1 IR Receiver The red LED is illuminated when receiving signals from the Infrared
remote control transmitter
2 POWER Switch Illuminated switch for turning the unit ON or OFF
3 IN SELECTOR Buttons Select the input to switch to the output (from 1 to 8).
When a signal is detected, the input button illuminates in green
4 OUT SELECTOR Buttons Select the output to which the input is switched (from 1 to 4)
5 OFF Button Press an OUT SELECTOR button and then an OFF button to disconnect
that output from the inputs
Press the ALL button and then the OFF button to disconnect all the
outputs
6 ALL Button Pressing ALL followed by an INPUT button, connects that input to all
outputs 1
7 TAKE Button Pressing TAKE toggles the mode between the Confirm mode 2 and the
At Once mode (user confirmation per action is unnecessary). When in
TAKE mode, pressing TAKE implements the action
8 STO (Store) Button Pressing STO followed by an input/output button stores the current
setting 3
9 RCL ( Recall ) Button Pressing the RCL button and the corresponding IN / OUT button recalls
a setup from the non-volatile memory 4
10 LOCK Button Disengages the front panel switches
11 STATUS 7-segment
Display
Displays the selected input switched to the output (marked above each
input) 5
1 For example, press ALL and then Input button # 2 to connect input # 2 to all the outputs
2 When in the Confirm mode, the TAKE button illuminates
3 For example, press STO and then the Output button # 3 to store in Setup # 3
4 See section 7.3.2
5 Also displays the number of IN and OUT ports, the firmware version number, and the MACHINE #. Refer to section 7.1