Kramer Electronics VP-8x4 - Manual (Page 9)

KRAMER: SIMPLE CREATIVE TECHNOLOGY
Your VP-8x4 8x4 VGA / UXGA Matrix Switcher
6
Table 2: Rear Panel VP-8x4 8x4 VGA / UXGA Matrix Switcher Features
# Feature Function
12 INPUT 15-pin HD (F) Connectors Connect to the video sources (from 1 to 8)
13 OUTPUT 15-pin HD (F) Connectors Connect to the output acceptor (from 1 to 4)
14 RS-232 9-pin D-sub (F) Port Connects to the PC or the Remote Controller
15 FLASH PROG Button Push in for “Program” to upgrade to the latest Kramer
firmware (see section 8), or release for Normal (the factory
default) 1
16 DELAY Dipswitches Dipswitches for setup of the unit ( DELAY dips 1, 2, 3 are for
setting the delay time) 2
17 SETUP, and RS-485 TERM
Dipswitches
Dipswitches for setup of the unit ( SETUP dips 1, 2, 3, 4 are for
setting machine #; 8 is for RS-485 Termination) 3
18 ETHERNET RJ-45 Connector Connects to the PC or other Serial Controller through computer
networking
19 RS-485 Terminal Block Port Pin G is for Ground connection; Pins B (-) and A (+) are for
RS 485
20 REMOTE IR 3.5mm Mini Jack Connect to an external IR receiver unit for controlling the machine
via an IR remote controller (instead of using the front panel IR
receiver) 4
21 Power Connector with Fuse AC connector enabling power supply to the unit
Figure 2 illustrates the underside of the VP-8x4 unit, and Table 3 defines the
underside features.
Figure 2: VP-8x4 8x4 VGA / UXGA Matrix Switcher Underside View
Table 3: VP-8x4 8x4 VGA / UXGA Matrix Switcher Underside Panel Feature
Feature Function
RESET FOR PROGRAM Button Press to reset unit prior to firmware upgrade (see section 8)
1 The “RESET FOR PROGRAM” button is located on the underside of the unit
2 See section 6.5.1
3 See section 6.5.2
4 Optional. Can be used instead of the front panel (built-in) IR receiver to remotely control the machine (only if the internal
IR connection cable has been installed)