WIKA CS4L - Manual (Page 16)

Operating Instructions Temperature Indicating Controller CS4H / CS4L
V1.1 • 05/2006 - 16 -
5. Setup
For the thermocouple and RTD inputs, the sensor input characters and temperature unit are indicated on the
PV display and the input range high limit value is indicated on the SV display for approximately 3 seconds
after the power is turned on (Table 5-1).
For DC input, the sensor input characters are indicated on the PV display and the scaling high limit value is
indicated on the SV display for approximately 3 seconds after the power is turned on (Table 5-1).
If any other value is set in the scaling high limit setting, the set value is indicated on the SV display.
During this time, all outputs and the LED indicators are in OFF status.
Control will then start and the input value will be indicated on the PV display and main setting value will be
indicated on the SV display. While control output OFF function is working,
is indicated on the PV dis-
play. To cancel control output OFF function, press the OUT /
OFF
key for approximately 1 second.
(Table. 5-1)
°C °F
Sensor input
PV display SV display PV display SV display
K
J
R
S
B
E
T
N
PL-
C (W/Re5-26)
Pt100
JPt100
4 … 20 mA DC
0 … 20 mA DC
0 … 1 V DC
0 … 5 V DC
1 … 5 V DC
0 … 10 V DC
Scaling high limit value