WIKA CS4L - Manual (Page 17)

Operating Instructions Temperature Indicating Controller CS4H / CS4L
V1.1 • 05/2006 - 17 -
5.1 Setup flow chart
MODE
PV/SV display mode
OUT /
OFF
(Approx. 1s)
Control output OFF
function [
] (*1)
Output manipulated
variable
MODE (Approx. 3s)
MODE ▲ + MODE ▼ + MODE (Approx. 3s)
[Main setting mode] [Sub setting mode] [Auxiliary function setting mode1]
SV 1
[ ]
AT setting/Auto-reset
setting [ / ]
Setting value lock
selection [
]
MODE MODE MODE
SV 2
[ ]
OUT1 proportional
band setting [ ]
SV high limit setting
[ ]
MODE MODE MODE
OUT2 proportional
band setting [
]
SV low limit setting
[ ]
MODE MODE
Integral time setting
[ ]
Sensor correction
setting [ ]
MODE MODE
Derivative time setting
[ ]
Communication
protocol [ ]
MODE MODE
ARW setting
[ ]
Instrument number
setting [ ]
MODE MODE
OUT1 proportional
cycle setting [ ] Data transfer rate
selection [ ]
MODE MODE
OUT2 proportional
cycle setting [
]
Heater burnout Alarm
setting [ . ]
Parity selection
[ ]
MODE MODE MODE
A1 setting
[ ]
Loop break Alarm
action time [
]
Stop bit selection
[ ]
MODE MODE MODE
A2 setting
[ ]
Loop break alarm
action span [
]
MODE MODE
•
▲
+ MODE: Press the MODE key, while the
▲
key is being pressed.
•
▼
+ MODE (Approx. 3s): Press the MODE key for approx. 3s, while the
▼
key is being pressed.
•
▲
+
▼
+ MODE (Approx. 3s): Press the MODE key for approx. 3s, while the
▲
and
▼
keys are being pressed.
• Dotted lines show options, which are indicated only when the options are applied.
(*1) If Auto/Manual control function is selected in the OUT /
OFF
key function selection, even though the OUT /
OFF
key is
pressed, control output OFF function does not work, but manual control is selected.