WIKA DI35 - Manual (Page 28)

6 Commissoning, operation
28 WIKA operating instructions digital indicator DI35-M
Change to the parameter
Once the program number appears in the display, you can push the
[▼] or
[▲] key to get to the parameters set for this program number. Es erscheint
für einen kurzen Moment „SCALE“ in der Anzeige. The currently stored
parameters are displayed.
Changing a parameter
After changing to the parameter, the lowest digit of the respective parameter
flashes on the display. The value can be changed with the
[▲] or [▼] key. To
move to the next digit, the [P] key must be briefly pushed. Once the highest
digit has been set and confirmed with [P], the lowest digit will begin to flash
again.
Example:
The 0 is flashing this is the lowest digit and asks
if you want to change it. Let us assume the figure
is to be changed from 75,640 to 75,000.
Briefly push the [P] key to move to the next digit.
The 4 begins to flash. Change the figure by
pushing
[▲] or [▼] to change the digit from 4 to
0. Briefly push the [P] key to move on to the next
digit. The 6 begins to flash. Change the digit by
pushing
[▲] or [▼] to move the 6 to a 0. Briefly
push the [P] key to move to the next digit. The 5
and 7 do not need to be changed.
Information
If a minus shall be displayed for negative values, the leftest
digit of the 7 segment display has to be activated (it blinks).
The minus can be activated with the
[▼] key.
Saving of parameters
All parameters must be acknowledged by the user by pushing the [P] key for
one second. The changed parameters are then taken over as the current
operating parameters and saved in the EEPROM.
This is confirmed by horizontal bars lighting up in the display.
All the newly entered data are confirmed by the unit. If no confirmation is
received, the relevant parameters have not been saved, e.g. confirmation of
parameters: