Konica Minolta bizhub PRO 920 - Manual (Page 132)

Configuring the Network Scanner features 8
bizhub PRO 920 Scanner 8-11
4
In the [Scanner Box No. Setting]
window, input a [Scanner Server
name (IP address)] to which you
connect, a [Scanner Name] for iden-
tification by the driver, a [Box No.]
specified when an original was
scanned, a [Password] configured
for the Box No., and click the [OK].
Go to the step 6.
– Once you configure the scanner
settings, this window does not appear the next time.The [Scanner
Selection] window (step 5) appears.
– To scan with another scanner, click the [Add] in the [Scanner Selec-
tion] window.
– For a Scanner Server name (IP address), input the IP address of the
print controller. For more information, contact your administrator.
– You cannot use a DNS name or a NetBIOS name for a Scanner
Server name (IP address).
– Multiple computers cannot access to one box simultaneously.
– At maximum, 5 computers can connect to one scanner simultane-
ously.
The [KONICA MINOLTA Scanner Driver] window appears.
5
In the [Scanner Selection] window, select the [Box No.] in which the
scanned data you import are stored, and click the [Connect].
6
Select a file from the file list shown
in the [KONICA MINOLTA Scanner
Driver] window, then click the
[Reading] to allow the selected file
to be read in.
– By default, the file is cleared
from the controller's hard disk
immediately after the file is fully
read in. If you want, you can
override this default setting so
that the file is held in the hard
disk.
– Refer to "Features and Settings
of the Network Scanner Driver" on Page 8-13 about the settings.
– Refer to "Deleting images stored on the HDD" on Page 8-12 about
how to delete scanned data.
– Only data for which TIFF was selected as the file form is displayed.
The selected file is read from the hard disk.
00_920_scan_e.book Page 11 Thursday, April 28, 2005 5:04 PM