Konica Minolta bizhub PRO 920 - Manual (Page 64)

About the Copied Data Processing Features 4
bizhub PRO 920 Scanner 4-29
!
Detail
An administrator needs to specify the IP Address of the target computer
on the copier. For more information, contact your administrator.
For more information on PageScope JobEditorServer, refer to "Page-
Scope JobEditorServer" on Page 11-9.
PageScope JobEditor and PageScope JobEditorServer for USA are ex-
cluded.
About how to obtain PageScope JobEditor and PageScope JobEditorS-
erver, contact your service representative.
Configure the automatic transmission to the PC in the following steps.
1
Press [Box] on the control panel and
then press [Store] key.
2
Press the [Change Data Send Sys-
tem] key.
3
Press the [Transmit to PC] key.
– If you have not specified a target
computer on the copier, you
cannot select the [Transmit To
PC] key. For more information,
contact your administrator.
4
Press the [OK] key to close the screen.
00_920_scan_e.book Page 29 Thursday, April 28, 2005 5:04 PM