Konica Minolta bizhub PRO 920 - Manual (Page 111)

7 Using the Network Scanner Features
7-12 bizhub PRO 920 Scanner
7.4 Transmission to the FTP server
When you send the scanned data to an FTP server, necessary procedures
depend on whether the FTP server is registered in advance or it is input man-
ually.
!
Detail
Refer to the following pages.
"When an FTP server is Already Registered" ...................... p.7-12
"When an FTP server is Input Manually"............................. p.7-14
When an FTP server is Already Registered
1
Press the [Scan] on the control panel.
The Select Destinations/Storage Locations screen appears.
2
Press the [FTP] key.
– In the initial settings, the Select
Destinations/Storage Locations
screen (E-Mail) is displayed. For
information on the initial settings
of the Scan screen, contact your
administrator of the copier.
3
If you need to change the Port No.,
press the [Port No.] key. If unneces-
sary, go to the step 5.
4
Input a Port No. and press the [OK]
key.
– The initial setting is 21. A Port
No. for an FTP server is config-
ured in 5-digit numbers (1-
65535).
– A Port No. is usually not changed. If you want to change the Port
No., consult with a network administrator.
00_920_scan_e.book Page 12 Thursday, April 28, 2005 5:04 PM