Konica Minolta ScanDiva - Manual (Page 87)

Chapter 4 Operation
4-19
7.4 Bound with special binding
When the binding section of the book has a special design and the surface of the
original is more than 50 mm (2 inch) above the book table as shown in the figure,
press the center of the book table so that the binding section is lowered to the
extent that the Auto Focus function is effective.
50 mm (2 inches)
50 mm (2 inches)
Push the center of the book table with your hands (see figure). The depth can be
adjusted to two levels.
Push down either side of the table and to return the center of the book table to its
normal position.
The table position will be locked once scan is started, then it will be released soon
after scanning is completed.
CAUTION
Use care to prevent your fingers, etc., from being pinched by moving parts while adjusting the
book table.