Konica Minolta ScanDiva - Manual (Page 29)

Chapter 2 Overview
2-3
2 Part Identification and Functions
1. Head
Unit: The CCD sensor is housed in this unit. This sensor scans the
original.
2. Lamp Unit: Illuminates the original evenly for accurate scanning.
3. Operation Panel: Displays the operation status of the Scanner, and is used to set
scanning conditions.
4. Book Table: Place the original (book, sheet) face up on this table.
Enables enhanced scanning of book originals by adjusting to
the contours of the book. See pages 4-8 through 4-13 for
detailed information and limitations.
5. Power Switch: Turns the Scanner ON/OFF.
6. Power Cord Socket: Plug the Power Cord into this socket.
7. USB Connector: Connect the USB Cable that is supplied with the equipment.
8. Manual Switch Connector: Connect the Manual Switch (option).
The switch to be used as the "right scan" button should be
connected to the left connector of the above figure.
The switch to be used as the "left scan" button should be
connected to the right connector of the above figure.
5
1
2
4
14
3
12 13
10
9
11
7
6
8