8 white balance, White balance -19 – Konica Minolta ScanDiva User Manual
Page 49
Advertising
Chapter 3 ScanDIVA TWAIN Driver
3-19
2.8 White Balance
This procedure is to adjust the color balance.
1
Remove the “White Paper” and then place the “Setup Adjustment Sheet” on
the Adjustment Plate.
NOTE !
Refer to “2.4 CCD Gain” above to place the “Setup Adjustment
Sheet”. If the glass plate is attached, close it.
2
Select “7. White Balance” on the pull-down list under “Detail & Adjustment”,
and then click “Run”.
3
Click “OK” on the confirmation screen to confirm the test chart.
4
The window indicating that adjustment is underway will appear. When the
window disappears, the adjustment is completed. Proceed to the next
adjustment, “2.9 Tone Curve”.
Advertising