Konica Minolta bizhub 42 - Manual (Page 30)

bizhub 42/36 4-4
4.1 About Start, Stop, Reset, C (Clear), and Power Save 4
4.1 About Start, Stop, Reset, C (Clear), and Power Save
Start
%
Start the copy, scan or fax operation.
Press this key again to restart a suspended job.
% When this machine is ready to begin the operation, the indicator on the Start key lights up in blue.
If the indicator on the Start key lights up in orange, the copy operation cannot begin. (Check that
no warning or message is displayed in the Touch Panel.)
Stop
%
Press the Stop key while copying to temporarily stop the scanning or printing operation.
% To resume a temporarily stopped job, press the Start key.
% To delete a temporarily stopped job, select a job in the suspended job list in the screen, and press
the [Delete] key.
Reset
Press this key to reset settings (except programmed settings) entered using the Control Panel and Touch
Panel.
%
Press the Reset key.
The each settings screen appears.
C (Clear)
Clears a value (such as the number of copies, a zoom ratio and size) entered using the keypad.
%
Press C (Clear).
The value is deleted. Enter the correct value.
Power Save
To reduce power consumption of this machine, the following power save modes are provided.
0 Sleep mode can save more power than Low power mode, but needs longer warm-up time before being
ready to copy.
0 The factory setting of Lower power mode time is 15 minutes. The factory setting of Sleep mode is 60
minutes for bizhub 42 and 45 minutes for bizhub 36. If the time settings of Lower power mode and
Sleep mode are same, a higher priority is given to Sleep mode.
0 If the time setting of Low power mode is smaller than that of Sleep mode, the machine mode changes
from Lower power mode to Sleep mode after a lapse of the time specified in Sleep time setting.
0 If the time setting of Low power mode is greater than that of Sleep mode, a higher priority is given to
Sleep mode. Even after a lapse of the time specified in Lower power mode time setting, the machine
mode does not change from Sleep mode to Lower power mode.
0 The machine can receive jobs (PC print, Fax reception) during Lower power mode and Sleep mode.
Only in Sleep mode, the machine goes into Sleep mode again after completion of jobs (PC print, Fax
reception).
Name Mode activation condition
Low Power Mode This mode works after the machine is idle for more than the time specified
in [Low Power Mode Time Setting] when [Low Power Mode Setting] is set
to [ON] in Admin Settings.
Sleep Mode • This mode works after the machine is idle for more than the time spec-
ified in [Sleep Time Setting] of Admin Settings.
• This mode works when you press Power Save.