Konica Minolta bizhub C200 - Manual (Page 25)

C200 1-14
Specifying network settings 1
5
Touch [New Password], type in the SMTP authentication password, and then touch [OK].
6
Touch [Confirm New Password], type in the SMTP authentication password again, and then touch [OK].
7
Touch [OK] in each screen until the initial screen appears.
!
Detail
In order to specify SMTP authentication settings, the software switch settings must be specified. For
details, refer to
"Specifying security settings for e-mail transmissions (mode 380)" on page 2-14 .
It is not necessary to specify these settings if the SMTP authentication user name and password are
the same as the POP3 user name and password.
1.3.6 SMTP RX Settings
Parameters
If settings have been specified for the SMTP authentication user name and SMTP authentication password
on the machine receiving the IP address fax or on the relay station for an IP relay operation, the SMTP
authentication user name and SMTP authentication password must be specified on the machine sending the
fax.
- The sender settings for an IP address fax can be specified when registering a one-touch dial destination
or when directly entering the number to be dialed. For details on specifying the settings when
registering a one-touch dial destination with Assistant tool for C200, refer to
"Registering, editing and
deleting one-touch dial buttons" on page 3-15 . For details on specifying the settings when
registering a one-touch dial destination or when directly entering the number to be dialed from the
control panel, refer to the User’s Guide [Network Scan/Fax/Network Fax Operations].
- Specify sender settings for IP relay operations with the settings for "IP Relay Destination Registration"
in the IP Relay Settings screen. For details, refer to
"IP Relay Settings" on page 1-33 .
2
Reminder
After changing the settings for these parameters, the machine must be turned off, then on again.
Parameter Description
Self-Domain Name Specify the domain name of this machine.
With a comparison of domain names during SMTP reception (IP address fax and IP relay
operations), reception from any number of people can be prevented.
An IP address fax is received only when the setting for "Self-Domain Name" on the recip-
ient’s machine matches that specified for "Self-Domain Name" on the sender’s machine.
An IP relay is received (relayed) only when the setting for "Self-Domain Name" on the re-
cipient’s machine (relay station) matches that specified for "Domain Name" ("IP Relay Des-
tination Registration" in the IP Relay Settings screen) on the sender’s machine.
If either the recipient’s machine or sender’s machine is not yet registered, it is considered
a match.
SMTP Authentication
User Name Specify the SMTP authentication user name used with SMTP authentication.
SMTP Authentication
Password Specify the SMTP authentication password used with SMTP authentication.
Exception Setting Specify the range of unauthenticated IP addresses that are permitted as exceptions during
SMTP authentication.