Konica Minolta bizhub C200 - Manual (Page 80)

C200 2-31
Specifying machine functions (software switch settings) 2
Maximum reduction ratio:
Since excess longer than the length specified by bits 7, 6 and 5 is reduced to fit within the paper, specify the
maximum of this reduction ratio. (Available only if bit 1 is set to "0" while printing received documents.)
For example, if "90%" is specified, it is reduced to a range of 100 → to 90%. The excess is printed on a
separate page if it does not fit within the printable area of the page with the maximum reduction ratio specified
here.
Process performed on the trailing end:
Specify whether the document is reduced or the excess is discarded when the received document is longer
than the printable area of the paper. (Available only when printing received documents.) The settings for bits
7, 6 and 5 and bits 4, 3 and 2 become available by specifying this setting.
2.5.15 Specifying the setting for selecting paper when printing received documents (mode
302)
Specify the settings for selecting paper when printing received documents.
Factory settings
Specifying the settings
During the production of this unit, the settings in the shaded cells were selected.
Bits 7654 3210
Settings 0000 0000 (HEX: 00)
Bits Description Settings Details
7 Specify how to determine whether or not there is paper.
(Available only when printing received documents.) 0 Paper priority method (de-
termined by whether or not
there is paper)
1 Paper tray priority method
(determined by the tray pa-
per size setting or the previ-
ous paper information,
regardless of whether or not
there is paper)
6-3 Specify the paper size according to the received image.
(Available only when printing received documents.) 0000 Selects the appropriate pa-
per from all loaded paper.
Others *Do not specify any settings
other than those mentioned
above.
2-0 − 000 *Do not change the settings
for these bits.