Specifying the settings (gateway tx), Specifying the settings (gateway tx) -24 – Konica Minolta bizhub C200 User Manual
Page 35
C200
1-24
Specifying network settings
1
6
Type the size into which e-mail messages are divided, and then touch [OK].
7
Touch [OK] in each screen until the initial screen appears.
!
Detail
Using the software switch settings, you can select the interval for sending divided messages. For
details, refer to
"Specifying settings concerning the transmission interval for divided e-mail
messages (mode 372)" on page 2-13
Specifying the settings (Gateway TX)
1
In the Network Settings screen, touch [Scanner Settings].
2
Touch [Gateway TX].
3
Select whether or not gateway transmissions are permitted, and then touch [OK].
–
If the fax multi line kit has been installed, touch [Allow] to change the communication mode for
gateway transmissions.
4
Touch [OK] in each screen until the initial screen appears.