Konica Minolta bizhub C200 - Manual (Page 51)

C200 2-2
Specifying machine functions (software switch settings) 2
2 Specifying machine functions (software switch settings)
2.1 Software switch settings
By specifying the software switch settings ("Mode Selection", "Bit Selection" and "HEX Selection"), various
machine functions can be changed to meet your specific needs.
2
Reminder
Do not change any modes or bits other than those described in this manual.
Examples of settings for "Bit Selection" (binary number) and "HEX Selection" (hexadecimal number) are
shown below.
Mode Selection Each parameter is expressed as a three-digit number. Use the keypad to type in
the value.
Bit Selection The bits are the eight numbers that represent the parameter status. By specifying
a binary number (0 or 1) for each of the bits (0 through 7), settings for each param-
eter can be specified.
HEX Selection Specify a setting for each mode as a hexadecimal number (0 through 9 and A
through F). Bit setting "0011 0000" is expressed as the hexadecimal setting "30".
Specify the status of each parameter by using either bits or hexadecimal values.
Decimal number "Bit Selection"
setting (binary
number) "HEX Selection" setting (hexadecimal number)
0 0000 0000 00
1 0000 0001 01
2 0000 0010 02
3 0000 0011 03
4 0000 0100 04
5 0000 0101 05
6 0000 0110 06
7 0000 0111 07
8 0000 1000 08
9 0000 1001 09
10 0000 1010 0A
11 0000 1011 0B
12 0000 1100 0C
13 0000 1101 0D
14 0000 1110 0E
15 0000 1111 0F
16 0001 0000 10
17 0001 0001 11
18 0001 0010 12
19 0001 0011 13
20 0001 0100 14
.
.
. .
.
. .
.
.
252 1111 1100 FC
253 1111 1101 FD
254 1111 1110 FE