Konica Minolta bizhub C200 - Manual (Page 65)

C200 2-16
Specifying machine functions (software switch settings) 2
SMTP authentication is enabled when the following conditions are met.
- Bit 6 of mode 383 is set to "1".
- Bit 5, 4 or 3 of mode 383 is set to "1".
!
Detail
For details on specifying SMTP authentication settings for e-mail receptions, refer to "SMTP RX
Settings" on page 1-14 .
If all e-mail authentication methods are enabled (bits 5, 4 and 3 of mode 383 are set to "1"), they will
have the following priority: CRAM-MD5 authentication (bit 5)
→ LOGIN authentication (bit 4) → PLAIN
authentication (bit 3).
2.4.13 Specifying settings concerning the network protocol (mode 384)
Specify settings concerning the network protocol.
Factory settings
Specifying the settings
During the production of this unit, the settings in the shaded cells were selected.
Bits 7654 3210
Settings 1111 1111 (HEX: FF)
Bits Description Settings Details
7 Specify whether or not the TCP/IP protocol is used. 0 Not used
1 Used
6 Specify whether or not the LPD protocol is used. 0 Not used
1 Used
5 Specify whether or not the RAW port protocol is used. 0 Not used
1 Used
4 Specify whether or not the SLP protocol is used. 0 Not used
1 Used
3 Specify whether or not the FTP client protocol is used.
(Specify whether or not to allow Scan to FTP operations to
be programmed.) 0 Not used
1 Used
2 Specify whether or not the FTP server protocol is used. 0 Not used
1 Used
1 Specify whether or not the SNMP v1/v2c protocol is used. 0 Not used
1 Used
0 Specify whether or not the SNMP v3 protocol is used. 0 Not used
1 Used