Konica Minolta Fujitsu Scanner - Manual (Page 154)

134
6.2 Error messages of the Operator panel
■ Hardware Alarms
[E] and a number will be displayed alternately.
Display Meaning Solution
E0 Error in the Hopper or Stacker When you encounter any alarm, turn off and on the
scanner. If the alarm is still displayed on the Func-
tion Number Display, contact the dealer where you
purchased the scanner or an authorized FUJITSU
scanner service provider.
E2 Optical system error (front)
E3 Optical system error (back)
E4 The motor fuse has blown out.
E5 The lamp fuse has blown out.
E6 Operator panel error
E7 Trouble occurred in the internal memory
(EEPROM).
E8 The SCSI fuse has blown out.
E9 Image memory error
EA Imprinter error
Ec Image memory error
Ed SCSI interface or USB interface controller error
EF Background switching mechanism error
E10 ROM error
E11 Cooling fan error
E12 Heater error
E15 Extended memory error Confirm the following:
1. Is the used additional memory compatible?
2. Is the additional memory installed correctly?
3. Is the additional memory damaged?
Note that this error will be displayed only three
times after powering the scanner on. After that, the
scanner will perform scanning in the state of no
additional memory installed.
When you encounter this E15 error, turn off and on
the scanner. If the alarm is still displayed on the
Function Number Display, contact the dealer where
you purchased the scanner or an autho-rized
FUJITSU scanner service provider.
E16 Option board error When you encounter any alarm, turn off and on the
scanner. If the alarm is still displayed on the Func-
tion Number Display, contact the dealer where you
purchased the scanner or an authorized FUJITSU
scanner service provider.
E17 The imprinter fuse has blown out.
E18 Sensor error
E19 LSI error
E1A Troubles occurred in the communication inside
of the scanner.