16 imprinter selection – Konica Minolta Fujitsu Scanner User Manual
Page 212
192
8.16 Imprinter Selection
8.16 Imprinter Selection
You can specify which imprinter to use; Pre-imprinter or Post-imprinter, if you already have installed these
options.
Configure the settings for the Imprinter Selection as follows:
1.
Start up the Software Operation Panel.
“8.1 Scanner Settings” on page 166
2.
Select the “Imprinter Selection” setting on the [Device Setting 2] tab.
3.
Select the Imprinter to use.
Normal (obey Host specification): Complies
with
the scanner driver setting.
Forcibly select Pre-imprinter:
Pre-imprinter is forcibly used to print unless directed by
the scanner driver.
Forcibly select Post-imprinter:
Post-imprinter is forcibly used to print unless directed by
the scanner driver.
HINT
For details on the specifications of the imprinter, refer to