Konica Minolta Fujitsu Scanner - Manual (Page 22)

2
1.1 Names and Functions of Parts
1.1 Names and Functions of Parts
This section describes the names of parts.
■ Front side
No. Name Function
1 Stopper Prevents ejected documents from dropping off the scanner.
2 Stacker side guide For aligning ejected documents to a certain width.
3 Top cover Cover to access the consumables storage box and Post-Imprinter
option (sold separately).
4 Stacker Documents will be ejected into the Stacker after scanning.
5 Ejector For ejecting the documents after scanning.
6 Operator panel For operating the scanner.
7 Stacker extension For scanning long documents. Pull the extension out according to
the document’s length.
8 ADF cover Open the cover for cleaning the inner parts of the ADF or for
replacing consumables.
9 ADF cover open button Button used to open the ADF
10 Pre-imprinter cover For the Pre imprinter option
11 ADF
(Automatic document feeder) The documents loaded onto the Hopper will be fed sheet by sheet
for scanning.
12 Hopper extension Pull the Hopper extension out for loading long documents.
13 Hopper Documents to be scanned are loaded onto the Hopper.
14 Hopper side guides Sheet Guides used to make sure that the paper to be scanned is
fed into the scanner straight, avoiding skew.
15 Power button Switch the scanner ON&OFF.
6
7
8
9
10
11
14
12
13
1 2 3 4 5
15