Barco R9002790 - Manual (Page 20)

4-1
Connections
R5976336 BARCOSLM R6 Executive 06092001
4
 
 
 
 
  
 
 
 
 
( 17(5
D
3$86(
 
3+$6(
)5((= 7( ;7
(;,7 $'-
67%<
6+$531 (66
7,17
&2/25
%5,* +71(66
&2175$67
+( /3
"
&2/25 3+$6(
6+$531 7,17 %5,*+71
67$1'%<
(17(5
7(;7
(;,7
3$86(
 
 
 



&2175$67
$
Fuses
Warning
For continued protection against fire hazard :
- refer replacement to qualified service personnel
- ask to replace with the same type of fuse.
Switching ON
Use the power switch to switch on.
When '0' is visible, the projector is switched off.
When '1' is visible, the projector is switched on.
When switching on with the power switch, the projector starts in the stand by mode. The projector mode indication lamp is red.
To start image projection :
a. press the 'Stand by' button A on the local keypad or on the remote control. The projector mode indication lamp will be green.
b. press a digit button to select an input source. The projector mode indication lamp will be green.
CONNECTIONS
Power Connection to Projector
AC Power (mains) cord connection
Use the supplied power cord to connect the projector to the wall outlet. Plug the female power connector into the black male connector
on the side of the projector.
The power input is 230 VAC.
Needed power connection : 7 A.
230V/7A
50/60Hz