Barco R9002790 - Manual (Page 53)

7-12
Random Access Adjustment Mode
R5976336 BARCOSLM R6 Executive 06092001
Select with é or ê
then <ENTER>
<EXIT> to return.
PICTURE TUNING
CTI [ON]
COLOR TEMPERATURE
GAMMA
DECODING [EBU]
DYNAMIC COLOR DEPTH
NOISE REDUCTION
INPUT BALANCE
ADJUST
RED WITH é OR ê
BLUE WITH ç OR è
Noise Reduction
Purpose :
Reduces noise and pixel jitter in all video and data sources.
To change the noise reduction value :
1 Push the cursor key é or ê to highlight 'Noise Reduction'.
2 Press ENTER to select.
3 Change the value by pushing the cursor key ç or è until the desired noise level is reached.
Adjustment range : 0 ... 8
4 Press EXIT to return to the Picture Tuning menu.
NOISE REDUCTION
0 8
Select with é or ê
then <ENTER>
<EXIT> to return.
PICTURE TUNING
CTI [ON]
COLOR TEMPERATURE
GAMMA
DECODING [EBU]
DYNAMIC COLOR DEPTH
NOISE REDUCTION
INPUT BALANCE
menu 1
menu 2
Input Balance
Why adjusting the input balance ?
The input balance is normally correct adjusted in the factory. But due to signal distribution or signal transmission, a color imbalance
can be the result. This imbalance can be adjusted source by source for color critical applications. These adjustments influence only
the actual custom adjustment file. This procedure is not so easy.
Attention : Before starting the Input Balance function, generate a signal with dominant black and white areas (e.g. image 1)
ATTENTION: there are 2 different adjustment procedures, one for RGB (included Video and S-Video) and ane for YUV
input signals.
How to adjust the input balance for RGB (Video and S-Video included) input signals ?
The default values are normally loaded when selecting a source. If the image is not as desired, adjust for this source as follow :
1 Push the cursor key é or ê to highlight 'Input Balance ' (menu 1).
2 Press ENTER to select.
The Input Balance menu will be displayed (menu 2).
Start with the Black Balance :
1 Push the cursor key é or ê to highlight 'Black Balance' (menu 2a).
2 Press ENTER to select.
3 Put the Black Balance Red and Blue to -32
4 Adjust the Brightness to a maximum value until there is just no green noise visible in the black areas.
5 Adjust with the cursor key é or ê or ç or è until there is just no red or blue noise visible in the black areas.
Continue with the White Balance :
1 Push the cursor key é or ê to highlight 'White Balance' (menu 2b).
2 Press ENTER to select.
3 Put the Gain Red and the Gain Blue to -32.
4 Adjust the Contrast to a maximum value until the green noise becomes visible in the white areas and return one step.
5 Adjust with the cursor key é or ê or ç or è until the red respectively blue noise becomes visible in the white areas and return
one step.
menu 1 menu 2b
Image 1
ADJUST
RED WITH é OR ê
BLUE WITH ç OR è
menu 2a
INPUT BALANCE
WHITE BALANCE
BLACK BALANCE
DEFAULT
INPUT BALANCE
WHITE BALANCE
BLACK BALANCE
DEFAULT