Barco R9002790 - Manual (Page 25)

4-6
Connections
R5976336 BARCOSLM R6 Executive 06092001
How to change the input slot setting
1 Press ADJUST or ENTER key to start up the Adjustment mode.
2 Push the cursor key é or ê to select Installation (menu 1)
3 Press ENTER.
4 Press the cursor key é or ê to select 'Input Slots' (menu 2)
5 Press ENTER. The internal system will scan the inputs and displays the result in the 'Input Slots' menu.
6 Push the cursor key é or ê to select the first or second slot (menu 3).
7 Press ENTER key to toggle the input signal priority.
Possible indication :
RGB-SS [CS or HS&VS] = RGB analog signals, separate sync is composite sync or horizontal and vertical sync.
RGB-SS [CV] = RGB analog signals, separate sync is composite video.
RGB-SOG [SOG or 3LSOG] = RGB analog signals, sync on green is composite sync or composite tri-level sync.
COMPONENT VIDEO - SS [SS or 3LSS]
= separate sync is composite sync or composite tri-level sync.
COMPONENT VIDEO - SOY [SOY or 3LSOY]
= component video with composite sync on Y or composite tri-level sync on Y.
VIDEO
S-VIDEO
PANELLINK
When changing from an analog signal on the 5 cable module to the panellink input the indication led on the front panel of the module
will switch from the 5 cable input to the DVI (panellink) input also.
Note for RCVDS05 users.
When using an RCVDS 05 with a 5 cable output module, connect these 5 cables to this fixed 5-input slot (slot1) of the projector.
All sources of the RCVDS can now be accepted by the projector.
Select with é or ê
then <ENTER>
<EXIT> to return.
ADJUSTMENT MODE
Select a path from below :
RANDOM ACCESS
INSTALLATION
SERVICE
INSTALLATION
INPUT SLOTS
800 PERIPHERAL
CONFIGURATION
OSD COLOR
INTERNAL PATTERNS
NO SIGNAL
LENS
QUICK ACCESS KEYS
MENU POSITION
INPUT SLOTS
Slot Module type [Config]
1. RGB-SS [CV]
2. RGB-SOG
3. SDI
4. SDI
Select with é or ê
<ENTER> to toggle
<EXIT> to return.
Select with é or ê
<ENTER> to toggle
<EXIT> to return.
menu 1 menu 2 menu 3