Getting started, Operating the projector switching on, Lamp run time indication – Barco R9002790 User Manual

Page 32: Lamp run time warning

Advertising
background image

5-3

Getting Started

R5976336 BARCOSLM R6 Executive 06092001









































( 17(5

D

3$86(





3+$6(

)5((=

7( ;7

(;,7

$'-

67%<

6+$531 (66

7,17

&2/25

%5,* +71(66

&2175$67

+( /3

"

&2/25

3+$6(

6+$531

7,17

%5,*+71

67$1'%<

(17(5

7(;7

(;,7

3$86(





















&2175$67

$

Operating the Projector

Switching on

Use the power switch to switch on.

When '0' is visible, the projector is switched off.

When '1' is visible, the projector is switched on.

When switching on with the power switch, the projector starts in the stand by mode. The projector mode indication lamp is red.

To start image projection :

a. press the 'Stand by' button A on the local keypad or on the remote control. The projector mode indication lamp will be green.

b. press a digit button to select an input source. The projector mode indication lamp will be green.

Lamp Run Time Indication

When starting up and the total run time of the lamp is 1470 hours or more, the lamp remaining run time will be displayed for 1 minute.

This warning message will be repeated every 30 minutes. Press EXIT to remove the message before the minute is over.

When the total run time of the lamp is 1500 hours or more, the following warning message, with the exact run time is displayed on

the screen. (Typical lamp lifetime is 1000 hours, max. lamp lifetime is 1500 hours).

Lamp run time is 1500 hours. Operating the lamp longer than 1500 hours may damage the projector. Please replace the lamp.

When OK (ENTER) is pressed to go on, the warning will be repeated every 30 min.

The total lifetime of the lamp for a safe operation is 1500 hours max. Do not use it longer. Always replace with a same type of lamp.

Call a BARCO authorized service technician for lamp replacement.

Lamp Run Time Warning

Using a lamp for more than 1500 hours is dangerous as the lamp could explode.

REMAINING LAMP RUN TIME

30 h

<ENTER> to continue

WARNING

Lamp run time is 1500 hours

Operating the lamp longer

than 1500 hours may damage

the projector.

Please replace the lamp

Advertising