Barco R9002790 - Manual (Page 59)

8-2
Installation Mode
R5976336 BARCOSLM R6 Executive 06092001
Select with é or ê
<ENTER> to toggle
<EXIT> to return.
Component video Component Video - SS : component video with separate sync
Component Video - SOY : component video with sync on Y
Component Video - 3LSS : component video with 3 level separate sync.
Component Video - 3LSOY : component video with 3 level sync on Y.
RGB analog with
tri-level sync RGB-SS[3LSS] : RGB with separate Tri level sync
RGB3L-SOG[3LSOY] : RGB with Tri level sync on green
Panellink Panellink
for the input 3 and 4 (digital slots) :
SDI : serial digital input
HDTV SDI : high definition digital input
What if a switcher is connected to the projector ?
If a RCVDS (switched on) or VS05 is connected to the projector, it will be also indicated on the menu by adding +800 peripheral. If
no 800 peripheral indication is made on the menu, there are still two possibilities :
- no RCVDS or VS05 connected or
- RCVDS is switched off.
When a 800 peripheral is connected to the projector, the input slots are not accessible with the cursor keys to toggle their function.
800 Peripheral
What can be installed ?
- The type of output module in a RCVDS05.
- The type of communication protocol.
Defining the Output module of the RCVDS05.
When a RCVDS05 is connected to the projector, the type of output module of this RCVDS05 has to be defined in the 800 peripheral
menu.
The type of output module can be :
- standard output module or
- 5 cable output module.
To define the output module :
1 Push the cursor key é or ê to highlight '800 Peripheral' (menu 1).
2 Press ENTER to select.
3 Push the cursor key é or ê to highlight 'Output module' (menu 2).
4 Press ENTER to toggle between 'Standard' or '5-cable'.
800 PERIPHERAL
menu 1
menu 2
OUTPUT MODULE [ STANDARD ]
INFRARED [PPM]
Select with é or ê
then <ENTER>
<EXIT> to return.
INSTALLATION
INPUT SLOTS
800 PERIPHERAL
CONVERGENCE
CONFIGURATION
OSD COLOR
INTERNAL PATTERNS
NO SIGNAL
LENS
QUICK ACCESS KEYS
MENU POSITION [DEFAULT]