Barco R9002790 - Manual (Page 61)

8-4
Installation Mode
R5976336 BARCOSLM R6 Executive 06092001
OSD COLOR
HIGHLIGHTED ITEM
RED
GREEN
YELLOW
Select with é or ê
then <ENTER>
<EXIT> to return.
menu 2
menu 1
Select with é or ê
then <ENTER>
<EXIT> to return.
How to change this color setting ?
1 Push the cursor key é or ê to highlight 'OSD Color' (menu 1).
2 Press ENTER to select.
3 Push the cursor key é or ê to desired color (menu 2).
4 Press ENTER to select.
menu 1
Select with é or ê
then <ENTER>
<EXIT> to return.
Configuration
What can be done ?
The way of physical installation of the projector can be defined to the projector.
The following installation configurations are possible :
- front/table
- front/ceiling
- rear/ceiling
- rear/table
Set up the Correct Configuration
1 Push the cursor key é or ê to highlight 'Configuration' (menu 1).
2 Press ENTER to select.
3 Push the cursor key é or ê to highlight the desired configuration.
4 Press ENTER to select.
For more information, see Projector configuration in chapter 3 : 'Installation Guidelines'.
OSD color (On-Screen Display)
What can be done ?
The highlighted items on the menus can be displayed in red, green or yellow.
INSTALLATION
INPUT SLOTS
800 PERIPHERAL
CONVERGENCE
CONFIGURATION
OSD COLOR
INTERNAL PATTERNS
NO SIGNAL
LENS
QUICK ACCESS KEYS
MENU POSITION [DEFAULT]
INSTALLATION
INPUT SLOTS
800 PERIPHERAL
CONVERGENCE
CONFIGURATION
OSD COLOR
INTERNAL PATTERNS
NO SIGNAL
LENS
QUICK ACCESS KEYS
MENU POSITION [DEFAULT]