Toshiba Tecra S2 - Manual (Page 104)

TECRA A3/S2 4-25
Operating Basics
Data Verification
To verify that data is written or rewritten correctly, follow the steps below
before you write or rewrite a Data CD/DVD.
1. Click the Options button ( ) on the RecordNow! Console to open the
Options panels.
2. Select the Data in the left-side menu.
3. Mark the Verify data written to the disc after burning check box in the Data
Options.
4. Click the OK button.
DLA for TOSHIBA
Note the following limitations when you use DLA:
■ This software supports only rewritable discs (DVD+RW, DVD-RW, and
CD-RW). It does not support DVD+R, DVD-R, and CD-R discs that are
not rewritable.
■ DLA does not support formatting a DVD-RAM disc and writing to it. They
are performed by DVD-RAM Driver Software. If DLA Format menu may
appear when inserting a DVD-RAM disc into the drive and right-clicking
the drive icon in Windows Explorer, please use "DVDForm" to format this
disc. You can run "DVDForm" by clicking the Start button on the taskbar
to display the Start menu and then selecting "All Programs", "DVD-RAM",
"DVD-RAM Driver" and "DVDForm" sequentially.
■ Do not use any discs that have been formatted with packet writing
software other than DLA. Similarly, do not use any discs that have been
formatted with DLA with any packet writing software other than DLA.
When using a disc you are not familiar with, format it by selecting Full
Format before using it.
■ Do not use the Cut & Paste function for files and folders. A file or folder
that has been cut may be lost if writing fails due to an error on the disc.
■ When writing the Setup files for the program into a disc formatted by DLA
and starting Setup from this disc, an error may occur. In this case, plase
copy them to your hard disk and then run Setup.
Video
You can record video using WinDVD Creator Platinum 2.
Installing InterVideo WinDVD Creator Platinum
To install the InterVideo WinDVD Creator, you must logon with administrator
rights. Before you install InterVideo WinDVD Creator, close all programs.
1. Insert the Additional Software CD-ROM that contains WinDVD Creator
Platinum into your optical disk drive.
2. Follow the installation instructions that appear on the screen.