Toshiba Tecra S2 - Manual (Page 147)

TECRA A3/S2 8-13
Optional Devices
Advanced Port Replicator III
In addition to the ports available on the computer, the Advanced Port
Replicator III provides serial port and separate ports for PS/2 mouse and PS/
2 keyboard. The Advanced Port Replicator connects directly to the docking
interface on the underside of the computer. The AC adaptor connects the
Advanced Port Replicator to a power source.
The following ports and accessories are available on the Advanced Port
Replicator III.
■ RJ45 LAN jack
■ RJ11 Modem jack
■ External monitor port
■ Parallel port
■ Serial port
■ PS/2 keyboard port
■ DC In 15V jack
■ Security lock slot
■ Audio line-in, line-out jacks
■ Universal Serial Bus 2.0 port (four)
■ i.LINK (IEEE 1394) port
■ DVI port
Slim Select Bay HDD adaptor
You can increase your computer's data storage capacity by installing an
additional 30.0 billion bytes (27.95 GB), 40.0 billion bytes (37.26 GB), 60.0
billion bytes (55.89 GB), 80.0 billion bytes (74.53 GB), 100.0 billion bytes
(93.16 GB), 120 billion bytes (111.78 GB)hard disk drive in the Slim Select
Bay.
The computer must be configured properly beore connecting to a LAN.
Logging onto a LAN using the computer's default settings could cause a
malfunction in LAN operation. Check with your LAN administrator regarding
set-up procedures.
■ You must connect the AC adaptor before you connect to an Advanced
Port Replicator III.
■ Priority is given to DVI port over CRT if DVI and CRT are connected
simultaneously.
■ DVI is supported by TECRA S2 only.