Toshiba Tecra S2 - Manual (Page 53)

TECRA A3/S2 2-4
The Grand Tour
Left side
The following figure shows the computer left side
The left side of the computer
1 2 3 4 5 3 6 7
1. P ARALLEL P ORT *
2. S-V IDEO P ORT
3. F AN V ENT
4. PC C ARD S LOT *
5. M ULTIPLE D IGITAL M EDIA CARD S LOT *
6. M ULTIPLE D IGITAL M EDIA C ARD S LOT A CCESS LED *
7. I .L INK P ORT *
* available depending on the model you purchased
Parallel Port This Centronics-compatible 25-pin parallel port is
used to connect a parallel printer or other parallel
device. This port supports Extended Capabilities
Port (ECP) standard.
(This function is available depending on the model
you purchased.)
S-Video Port Plug a 4-pin S-video cable into this connector for
output of NTSC or PAL signal.
FAN Vent FAN Vent helps CPU keep from overheating.
To prevent possible over heating of the CPU, never block the fan vent.
PC card Slot A PC card slot can accommodate two 5 mm PC
cards (Type II) or one 10.5 mm PC card (Type III).
You can install any industry standard PC card,
such as a SCSI adaptor, Ethernet adaptor or flash
memory card.
Depending on the model you purchased it is
provides one type II or two type II or one type III
pc card slot
Multiple Digital Media
Card Slot
The Multiple Digital Media Card Slot allows you
to use in digital still cameras and various forms of
portable information equipment.
(This function is available depending on the model
you purchased.)