Toshiba Tecra S2 - Manual (Page 88)

TECRA A3/S2 4-9
Operating Basics
Disconnecting LAN cable
To disconnect the LAN cable, follow the steps below.
1. Pinch the lever on the connector in the computer's LAN jack and pull out
the connector.
2. Disconnect the cable from the LAN hub in the same manner. Check with
your LAN administrator before disconnecting from the hub.
Wireless LAN
The wireless LAN is compatible with other LAN systems that comply with the
IEEE 802.11a+g and 802.11g wireless LAN standards.
It supports the following:
■ Automatic Transmit Rate Select mechanism in the transmit range of 54,
11, 5.5, 2 and 1 Mbit/s. Advanced Encryption Standard (AES) data
encryption, based on 128bit encryption algorithm. (Revision G, A/G
combo type.)
■ Frequency Channel Selection (5GHz and 2.4 GHz)
■ Roaming over multiple channels
■ Card Power Management
■ Wired Equivalent Privacy (WEP) data encryption. Wake-up on LAN does
not function on a wireless LAN.
Wireless LAN disclaimer
The transmission speed over the wireless LAN and the distance over which
wireless LAN can reach may vary depending on surrounding electromagnetic
environment, obstacles, access point design and configuration, and client
design and software/hardware configurations. The actual transmission
speed will be lower than the theoretical maximum speed.
To use the Atheros SuperAG
TM
or SuperG
TM
function, your client and access
point must support the corresponding feature. Performance of these
functions may vary depending on the format of data transmitted.
Security
1. Be sure to enable WEP(encryption) function. Otherwise you computer
will allow the illegal access by outside through Wireless LAN to cause
illegal intrusion, eavesdropping, and loss or destruction of stored data.
TOSHIBA strongly recommend the customer to enable the WEP function.
2. TOSHIBA is not liable for the eavesdropping of data due to the use of
Wireless LAN and the damage thereof.
Wake-up on LAN does not function on a Wireless LAN.