Bendix Commercial Vehicle Systems Bendix/King Global Positioning System KLN 35A - Manual (Page 139)

Appendix
B-2 Effective Date 5/95 006-08791-0000 Rev 0
Message Page Messages
Appendix B
Inside SUA
[name and type of special use airspace]
[altitude boundaries]
[responsible ATC facility] -- (Inside Special Use Airspace) This mes-
sage appears when the aircraft is inside special use airspace (SUA).
See section 3.15.
Magnetic Var Invalid All Data Referenced To True North — This
message appears when the magnetic variation is invalid due to -
operation outside of the data base magnetic variation area without
having a pilot-entered magnetic variation. See section 4.6.
No GPS Receiver Data — This message appears when the KLN
35A fails a specific internal test for the GPS receiver. This failure will
prevent the unit from providing any navigation capability.
OBS Waypoint > 200nm — (OBS mode waypoint greater than 200
nm away) This message is displayed when the KLN 35A is in the
OBS mode and the distance to the active waypoint is more than 200
nautical miles.
Other WPTs Deleted — (Other waypoints deleted) This message is
displayed whenever more than 10 waypoints used in a flight plan
(including the active waypoint) have been deleted.
Position of _______ has Changed -- This message appears when
either the latitude or the longitude of a waypoint used in a flight plan
or the active waypoint has changed by more than .33 minutes as a
result of updating the data base.
Positions of Other WPTs Have Changed -- This message appears
when the above message “ Position of _______ has Changed” would
be effective for more than ten waypoints..
RCVR HW Error: ____ -- (Receiver Hardware Error) This message
appears when the KLN 35A fails a specific internal test for the GPS
receiver. The blank will contain a numerical value which may provide
assistance to maintenance personnel.
Recycle Power to Use Valid Data Base Data -- This message
appears when the date entered on the Initialization page is before the
data base effective date and the date entered later on the SET 2
page is after the data base effective date, or vice versa. Turn the
KLN 35A off and back on so that the correct data base data is uti-
lized.