Bendix Commercial Vehicle Systems Bendix/King Global Positioning System KLN 35A - Manual (Page 29)

Data Base
2-6 Effective Date 5/95 006-08791-0000 Rev 0
Data Base Chapter 2
6. Press F . The estimated load
time in minutes is now displayed
(figure 2-4).
NOTE: In step 6, repeatedly pressing
E will terminate the update process
and bring the display back to the origi-
nal SET 3 page shown in figure 2-2 .
7. Press
F
to acknowledge the estimated load time and begin
erasing the existing data base. The unit will now display Erasing
data base. After the data base
has been erased, the loading of
the new data automatically
begins. As the new data is being
loaded, the percentage of transfer
is displayed (figure 2-5).
8. The KLN 35A will indicate when
the data base update is complete
as shown in figure 2-6. You may
either turn the KLN 35A off at this
point or press
F
to restart the
KLN 35A.
9. Remove the interface cable. Remove the disk from the com-
puter. Turn off the computer.
The chances are small of having difficulty updating the data base
but—
If you have a problem:
• First check that the interface cable is properly connected and that
the computer is turned on. If there is a problem with the
connection or the computer the KLN 35A will display Data
Loader Not Ready. When the problem is corrected this prompt
is removed and the update operation can continue from where it
left off.
• If an internal test fails after the data has been loaded, the KLN
35A will display Checksum Error, Data Base Invalid. Press
F
to acknowledge. The KLN 35A will then display Data Base
Update Failed, Retry? Use the right outer knob to position the
cursor over the desired choice and press
F .
APT VOR NDB SUP ACT NAV FPL CAL SET OTH
åå.ånm Programming
ееееее data base
>Leg 95% complete
CRSR
Figure 2-5
APT VOR NDB SUP ACT NAV FPL CAL SET OTH
åå.ånm Published data
ееееее base update
#>Leg complete
CRSR Acknowledge?
Figure 2-6
APT VOR NDB SUP ACT NAV FPL CAL SET OTH
åå.ånm Estimated load
ееееее time: 5 min
#>Leg
CRSR Approve?
Figure 2-4