Barco R5976924 - Manual (Page 195)

13. Configurator, Warp User Interface
13.4 Make node selection
Selecting a single node
1. Click on a node in the grid. (image 13-6)
An active area is created around that single node. This active area is created by connecting the adjacent
active nodes with each other. That is also the area that will be influenced by an adjustment of the
selected active node.
Image 13-6
Single node selection
Selecting multiple nodes
1. Double click on each active node that must be included in the selection. (image 13-7)
The active node symbol changes to an orange icon. An active area is created around each selected
node. Those active areas can overlap each other. Only the current selected active node has a yellow
background, all others in the selection have a light green background.
When moving one node in the selection, all other nodes will move in the same direction, except if they
are on the edges of the grid (a node cannot move outside the grid).
R5976924 PROJECTOR TOOLSET 16/04/2009 191